ENTAC ES-3S-RC Benutzerhandbuch Seite 5

EN USER MANUAL
Thank you for choosing ENTAC product! Please read the following instructions carefully before use.
PRECAUTIONS
1. Usage Information
The following equipment must not be connected to the remote control socket:
• Equipment beyond the technical values of the remote control socket (-> technical data).
• Appliances with motor capacitors (eg refrigerators, etc.).
• Unattended opening of the device can result in fire or other damage (eg iron, etc.).
• Cathode ray tube televisions.
• Do not use the remote control socket outdoors, near dripping water and in damp rooms (bathrooms, etc.).
• The remote control sockets must be quickly accessible in an emergency so that they can be removed from the grounded contact
socket in the event of a hazard.
2. Safety Information
• Do not plug multiple units into each other.
• No voltage only when the plug is disconnected.
• For dry rooms only.
• The remote control socket should only be connected to a properly installed ground contact socket (230V~ 50Hz).
• The remote control socket must not be plugged into an extension cord and must not be overloaded (2300W max).
• Do not open the device. Improper assembly may result in electric shock, short circuit or fire.
• The range of remote control sockets can be severely affected by structural conditions (eg reinforced concrete) or sources of
electrical/electromagnetic interference (fluorescent lights, cordless phones or headsets, TV/monitors, cables, etc.). If necessary,
remove the source of interference or maintain an appropriate distance.
• Keep the equipment installation at a distance of more than 80CM from the ground.
• Avoid moisture, extreme temperatures, vibration and shock.
• Clean with a soft, slightly damp cloth. Do not use detergents or solvents. Do not immerse in water.
• Do not insert pins or other metal objects into electrical outlets.
• Do not expose the battery to extreme temperatures such as direct sunlight or fire.
• Do not place the device on a heater. Leaked battery acid can cause damage.
• Always insert batteries with correct polarity (+ and –) as shown in the battery compartment.
• Notice! There is a danger of explosion if the battery is inserted incorrectly.
• When replacing batteries, only use batteries of the same type with the corresponding technical data.
• If the battery leaks, remove it from the battery compartment with a cloth. Dispose of batteries properly. If battery acid leaks,
avoid contact with skin, eyes and mucous membranes. In case of contact with acid, rinse affected area thoroughly with water
immediately and consult a doctor.
• Store batteries in a well-ventilated and dry place.
• Remove the battery if the device will not be used for an extended period of time.
• Explosion hazard! Batteries must not be charged or reactivated with other reagents, disassembled, thrown into fire, or
short-circuited.
• Remove used batteries from the device and dispose of them immediately.
Warning:
1. This product contains a CR2032 battery, which can cause severe internal burns within 2 hours and possibly death if swallowed.
2. Keep new and used batteries away from children.
3. If the battery compartment cannot be closed tightly, please stop using this product and keep it away from children.
4. If the battery may have been swallowed or entered any part of your body,please seek medical attention immediately.
A. PRODUCT STRUCTURE
1. Remote Control Socket
a. LED
b. ON/OFF
c. Pair
d. Reset
2. Transmitter
a. Indicator light
b. ON
c. OFF
d. All ON
e. All OFF