Retlux RSH 501 Wi-Fi Kurzanleitung Seite 13

Anti-theft security / installation and dismantling of the
doorbell
After installing the doorbell on the surface, secure the doorbell unit with
the supplied safety screw. A screwdriver is included in the package. When
inserting the unit, slide the bell into the weather cover with the top part all
the way in, then press the bottom part in. Be careful not to catch the edge
of the bell on the springs that are used to transfer power.
Charging
Charge the doorbell using a cable with a USB Type-C connector. Remove
the doorbell from the holder and remove the rubber cap at the back. Be
sure to replace this cap when charging is complete.
lux_RSH_501_booklet_7,5 x 13,5 cm 03.indd 13 lux_RSH_501_booklet_7,5 x 13,5 cm 03.indd 13
Transformer
13
09.05.2024 12:19:51 09.05.2024 12:19:51