Ahlmann AL70 Betriebsanleitung Seite 191

10.3 Maintenance plan
Item 8.1 Maintenance plan
- At the lubrication point (10-1/1) of the
central lubrication ledge the rear bolt
of the steering cylinder bearing every
50 operation hours greased.
- At the lubrication point (10-1/2) of the
central lubrication ledge the rear bolt
of the pendulum support every 50
operation hours greased.
Item 8.4 Maintenance plan
- Multi purpose bucket:
The four bolts of the cylinder bearing
must be greased every 10 operation
hours (10-2/1 to 10-2/4).
- Side dump bucket:
Both bolts of the cylinder bearing
(10-3/1 and 10-3/3) as well as the bolt
of the dump pivot (10-3/2) must be
greased every 10 operation hours.
1 2
Fig. 10-1
1
2
3
4
Fig. 10-2
1 2 3
Fig. 10-3
L06M
Central measuring station
NOTE
The central measuring station is in
the engine compartment located
and accessible through the rear
flap.
Measuring point
10-4/1
P-working hydraulic
10-4/2 Pilot pressure attachments and filling pressure
10-4/3 Drive hydraulic control pressure
10-4/4
Drive hydraulic control pressure
10-4/5 Drive hydraulic high pressure
10-4/6 Drive hydraulic high pressure
DANGER
The measuring range of the used pressure gauge must never be lower
than the values shown in above table for the different measuring points.
6 5 4 3 2 1
Afb. 10-4
Pressure gauge
to be used
250 bar
60 bar
X 40 bar
1
X 40 bar
2
M 600 bar
A
M 600 bar
B
L06M