Switch Modes - NEO ventilator ii Bedienungsanleitung

5.00 Off
LEVEL
Adjusts the overall output level of the Ventilator II. 12 o'clock is
the default position with the effect signal's level roughly equal
to the bypass signal.
IV. SWITCH MODES
If the SLOW/FAST switch is pressed and held for 3 seconds on
power up, the Ventilator enters an edit routine enabling the
user to adjust the switch behaviour of the STOP and SLOW /
FAST switch.There are 6 modes (see below) that can be
stepped through by pressing the Stop (decrement) or
Slow/Fast switch (increment): The Lo and Hi Leds indicate the
current setting:
Lo LED blinking 1x/sec, Hi LED off >>>
Lo LED blinking 2x/sec, Hi LED off >>>
Lo LED blinking 3x/sec, Hi LED off >>>
Hi LED blinking 1x/sec, Lo LED off >>>
Hi LED blinking 2x/sec, Lo LED off >>>
Hi LED blinking 3x/sec, Lo LED off >>>
Pressing Stop and Slow/Fast together for 2 seconds stores the
setting and leaves the edit routine. When SWITCH1 is selected
via the Remote parameter, the Switch Mode setting also
affects the external remote's switch behaviour.
28
Turns remote control off.
Mode1
Mode2
Mode3
Mode4
Mode5
Mode6