livn RFC03 Bedienungsanleitung Seite 3

3.
Settings
Power on the thermostat, press and hold the "SET" button until "W1"
start to flash, edit the weekday by pressing the "-" or "+" button, press the
"SET" button to confirm and goes to the time setting, pressing the "-" or "+"
button to edit the time, press again the "SET" button to confirm and goes
to the temperature calibration, you can calibrate the temperature sensor
from "-5 to 5" degree by pressing the "-" or "+" button.
(For factory reset: switch off the thermostat, press and hold the M
button for 15 seconds to reset to factory mode).
4.
Open window detection
This thermostat has an energy saving feature of Open window detection,
you can turn function on/off by long pressing the"-" button for 10
seconds.
5.
Adaptive start
This thermostat has an energy saving feature of adaptive start, you can turn
function on/off by long pressing the"+" button for 10 seconds.
6.
Heating operation mode
Press M button to shift between two operation mode, Mode1 means manual
mode, Mode2 means the program mode.