brennenstuhl Primera-Tec Automatic 15.000 A Bedienungsanleitung Seite 17

Primera-Tec
Starting the automatic
setting
1. Switch on the
main switch.
2. Plug the master device into the master socket.
3. Set the master device to the standby
switched off mode, if this is not already
4. Keep the "Learn"
secs., until the "Slaves on" lamp begins to flash.
5. The "Slaves on" lamp now flashes for some
seconds.
During this time, the standby
tion of the master device is automatically
mined and the switching
6. When the control
flashing, the setting
The automatic
Permanent mode
Activation
• Proceed as for the automatic setting of the
switching threshold.
• During the time that the "Slaves on" lamp flas
hes (Point 5), push the button
approx. 3 secs. The automatic
hold setting will be finished
mode for the
Deactivation
• Simply carry out an automatic
threshold setting
Operating
switching
automatic extension
button pressed for approx. 3
threshold
light "Slaves on" stops
process is finished.
extension socket
for the slave
slave sockets
again.
Instructions
threshold
socket
mode or
done.
power consump-
is stored.
can now be used.
sockets
"Learn" again for
switching thres
and the permanent
will be activated.
switching
at the
deter-
17