Maintenance And Sterilization; Suprasson Handpiece Maintenance - Satelec Cocoon Bedienungsanleitung

Micromotor connection
Connecting the micromotor to its lead is done by
simply screwing it in.
The two red reference marks must be lined up.
C
OCOON SPRAY
Attach the tube delivered with the contra-angle
to the small L-shaped outlet connector on the
micromotor (1).
1
Spray adjustment is achieved via the front panel
(Fig. 1-4).
In the case of prophylaxis contra-angle utilisation,
close the front spray valve in order to stop the
flow of irrigation.
On the front panel there is a three position button
(Fig. 1-5) for reversal of the motor rotation :
Left selector : clockwise rotation
Right selector : anti-clockwise rotation
Centre selector : no rotation
II - MAINTENANCE AND
STERILISATION
The following maintenance and/or sterilization
instructions must be performed prior to any
initial use of the handpiece or of the tip
provided with the instrument.

2. 1 SUPRASSON HANDPIECE MAINTENANCE

a) Maintenance of the Suprasson handpiece
(Fig. 5)
Handpiece body must be cleaned and disinfected
(e.g. with alcohol : 96% V/V ethanol or dental
disinfecting towelettes). The threaded cavity can
be cleaned by means of a cotton swab soaked in
alcohol. The handpiece must not be cleaned in an
ultrasonic bath.
Caution : DO NOT disconnect the handpiece
while the instrument is powered and the
control pedal is activated.
b) Sterilization of the Suprasson handpiece
Sterilization conditions and cycles according to
equipment:
Equipment : autoclave
Wet heat sterilization:
134°C under 2 bar (200 kPa) for 20 min.
• Detach the handpiece from its connecting cord
and remove the tip.
• Wrap the handpiece in a sterilizable cloth or
pouch, as required.
• Remove the handpiece from the autoclave as
soon as sterilization is complete.
• Carefully dry the electrical contacts of the
handpiece and cable connector before
connecting them.
8