Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CONTROLS
tact is covered by an insulating foil which must be removed before use.
Turn the remote control upside down. Grasp the insulating foil and pull it out. Turn the remote
control upright again.
Temperature and brightness settings
Press the remote control button briefly to change the colour tem-
perature in the following order: on 3000 K 4000 K 5000 K
6500 K off.
Long-press the remote control button to change brightness con-
tinuously.
Automatic brightness adjustment
Press the remote control button three times to activate automatic
brightness adjustment to the ambient light level. The indicator light
will glow blue.
The light sensor will detect the ambient light level and adjust the brightness of the lamp as
needed. When the environment is bright, the lamp dims, and vice versa.
To switch off the feature, long-press the remote control button.
Battery replacement
When the appliance begins begins responding to the remote inconsistently or not at all, the
remote's battery needs replacement.
1. Turn the remote control upside down and use a screwdriver to loosen the two screws at the
bottom. Remove the screws, then remove the battery compartment cover.
2. Remove the dead battery and insert a new CR2032 battery. Observe correct polarity when
inserting a battery.
3. Replace the battery compartment cover and secure it with the screws using a screwdriver.
Note:
Do not throw batteries into fire. Do not short-circuit or mechanically damage
them.
Pairing the remote control with the lamp
The remote control is automatically paired with the lamp at the factory and does not need to
be manually paired. If the pairing is broken (e.g. when changing the battery) or you replaced
your remote control, follow this pairing procedure:
1. Press and hold the remote control button.
2. Connect the lamp to a power source.
3. When all the lights on the remote control button light up and start flashing slowly, the
pairing has been successful.
ENGLISH
7
Werbung
