7.
Position the roller supports (A and B) together with the base (J) on the edge of the
(See fig. 30)
pool.
In case the edge is made of plastic or wood, use self-tapping screws (L) to fix the base (J) to the edge.
In the case where the edge is made of metal, first drill holes corresponding to the size of the opening
in the base (J). Secure the position of the support with the base by screwing it to the edge with a
screw and a nut (N).
If it is necessary to increase the length of the roller, loosen the three screws (O) on the tube (R) at
both ends of the roller. Adjust the length of the roller and tighten the screws (O) to secure the
connection.
8.
For pools with a tubular frame
(See fig. 31)
Position the roller supports (A and B) together with the base and the holder (K) on the frame and
tighten the screws in the base with the holder (K) so that the supports (A and B) are in a stable
position.
If it is necessary to increase the length of the roller, loosen the three screws (O) on the tube (R) at
both ends of the roller. Adjust the length of the roller and tighten the screws (O) to secure the
connection.
9.
Connect the strap (E), the clamp (G) and the clip (H).
(See fig. 32)
10.
Disconnect the male Velcro parts (F) from the strap (E) and remove the adhesive layer
(See fig. 33)
from the male part of the Velcro. Place the male Velcro parts (F) on the roller, perpendicular to its
axle at regular intervals, along the entire length of the pool.
11.
In the case of rectangular pools:
(See fig. 34)
Spread the cover over the pool. Mount the clips (H) (as shown in the figure) to cover, at regular
intervals, at a distance as the male Velcro parts (F) on the roller. Ensure that the length of the straps
allows covering to lie flat on the pool surface to prevent air from blowing under the cover.
12.
For round or oval pools:
(See fig. 35)
Spread the cover over the pool. Mount the clips (H) (as shown in the figure) to cover, at regular
intervals, at a distance as the male Velcro parts (F) on the roller. Ensure that the length of the straps
allows covering to lie flat on the pool surface to prevent air from blowing under the cover.
13.
To disassemble the product from the pool, pull the support (A) from the base (J) and
(See fig. 36)
turn the product against the axle of the second support. Make sure that the support is based on the
edge or disassemble the product completely.
3.3.
Cleaning and maintenance
a) Use cleaners without corrosive substances to clean each surface.
b) After cleaning the device, all parts should be dried before reusing it.
c)
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
d) Never spray the device with water jets.
e) Regular inspections of the device must be carried out in terms of its technical efficiency and any
damages.
f)
Use a soft cloth for cleaning.
EN