Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
To open the safe
A. Input the code (the original code set by factory is 1, 5,9), and press "A" or
"B", part of the model for the "C" or"E" (A and B, C and E are the function keys),
the green light on, please turn the key or knob in 5 seconds, (if there is handle,
please turn the handle first), and pull out to open the safe.
B. Each press the yellow light will flashing with the beep, indicating that
microprocessor confirmed it. if the yellow light keep on flash with the beep
means the code is wrong. Three times' wrong code will result the
microprocessor refuse to accept the input for 20 seconds, if press three times'
wrong code again will result the microprocessor refuse to accept for 5 minutes.
Close the safe
Close the door, and turn the key or knob (if there is handle, please turn the
handle to the vertical place).
To set and change the user code
A. Press the red button while the door is open, the yellow light will
be on, please input the user code in 30 seconds (3-8 bits),then
press "A" or "B" to finish.
B. The yellow light keep on flashing with beeps means the code is
wrong. To change the user code please repeat above.
How to use your override key
If you forget your code, first please take off the override cover beside the knob
or key, inset the override key and turn to left, th en rotate the knob or key (if
there is handle, please rotate the handle first), the door will be opened. Do not
put the override key in safe box.
The changing of battery
If the red light is on with green light indicating that you should change the
battery. To be sure the battery are installed correctly. Please have a test
before you close the door.
Knob or key
Override key
Green LED
Red LED
Yellow LED
Override cover
Werbung
