Servoreverse (Rev); Enter Model Names - GM-Racing 94011 Bedienungsanleitung

11 94011 GM-Racing XG-6 Race Spec Instructions
94011-eng.indd Druckbogen 5 von 8 - Seiten (12, 5) 94011-eng.indd Druckbogen 5 von 8 - Seiten (12, 5)
4.

SERVOREVERSE (REV)

This function reverses the direction of operation of the servos rela-
ted to transmitter steering, throttle, and channel 3 operation.
1. Press "ENTER" to see FUNCTION MENU.
2. Press "+" or "-" to choose REVERSE, and press "ENTER" to
enter REVERSE adjusting interface.
3. Press "ENTER" to choose each Channel.
4. Press "+" to increase and "-" to choose "REV" or "NOR".
5. Press "EXIT"to save your setting and leave REVERSE
interface, and back to the function menu interface.
Note: However, when the position set by trim or sub trim shifts from the center, the center
becomes the opposite side.
5. MODELL MEMORY (MDL)
Press "ENTER" in the power on interface, and enter function menu interface. Press
"+" or "-" to choose MDL, and press "ENTER" to enter MODEL adjusting interface.
1. Press "ENTER" to choose "mod00" (SEL).
2. Press "+" or "-"to choose "mod00~mod15".
3. Press "EXIT"to save your setting and leave SEL interface, and back to the function
menu interface.

ENTER MODEL NAMES:

1. Press "+" or "-"to choose "EDT".
2. Press "ENTER" to enter rename mode ,Press "+" or "-"to choose "0.1.2....I"
3. Press "ENTER" on the display to save your modifi ed and return to the MODEL Screen.
4. Press "EXIT"to save your setting and leave EDT interface, and back to the function
menu interface.
94011 GM-Racing XG-6 Race Spec Instructions 04
03.12.2008 08:16:56 03.12.2008 08:16:56