Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Safety notes for the use of LiPo batteries
X
X
Do not place the battery in water or any other liquid.
X
X
Do not place it in a microwave oven.
X
X
Avoid short-circuits, and never charge the battery with reversed polarity.
X
X
Avoid pressure or shock loads, and never distort or throw the pack.
X
X
Never solder directly to the battery or modify or open it.
X
X
Batteries must only be charged with a suitable charger. Never connect the battery directly to a mains PSU.
X
X
Never charge or discharge a battery in bright sunlight, or close to a heater or open fire.
X
X
Do not use the battery in areas with high levels of static discharge.
X
X
Any of these errors can result in damage to the battery, explosion or even fire.
X
X
Keep the battery out of the reach of children.
X
X
Do not allow escaped electrolyte to come into contact with fire, as it is highly inflammable, and may ignite.
X
X
If fluid electrolyte gets in contact with eyes, flush with copious amounts of clean water and contact a doctor without delay.
X
X
The fluid electrolyte can be removed from clothing and other objects by rinsing in plenty of water.
Liability exclusion
As manufacturers and vendors have no influence on the operation and maintenance of batteries, we bring these hazards express-
ly to your attention but deny all further liability.
Disposal restrictions
Electrical and electronic equipment should be disposed separately from the household waste. Take your unwanted
equipment to your local community collection point. This requirement applies to member countries of the European
Union as well as other non-European countries with a separate waste collection system. Never throw batteries into
normal household waste, but dispose of discharged batteries at the collection points provided for that purpose (e.g.
your local toxic waste disposal centre).
Component Description
Stabilizer bar
Main rotor
Coloured LEDs
White LED
(landing light)
Camera
Camera LED
Charging
socket
Video button
Charging cable
ON/OFF switch
Main rotor
Tail rotor
Red & blue LEDs
Slot for microSD card
Landing skid
Demo
Power LED
ight button
Turbo button
Charge LED
Control stick (left/right – forward/backward)
ON/OFF switch
Throttle stick
Right trim
Photo button
Light
Left trim
Channels
A - B - C
8
Contents
X
X
Camera helicopter
X
X
Remote controller with integrated charger
X
X
Flight battery pack LiPo 3,7V 280 mAh
X
X
Spare main rotor blades
X
X
Spare tail rotor blades
Recommended accessories
X
X
6 x AA 1.5 V batteries
Special product features
X
X
Chose from 3 channels to fly with 3 helicopters at the same time
X
X
Automatic channel search: Chose your channel on the remote
controller. The helicopter will automatically recognise the chosen
channel
X
X
Turbo function
X
X
Gyro inside
X
X
Overhead stabilizer bar
X
X
Flexible rotor blades
X
X
Robust aluminium frame
X
X
3 channel helicopter
Preparation
Inserting the transmitter batteries
Use a Phillips screwdriver to open the battery compartment
cover. Insert 6 x AA batteries with the correct polarity and
replace the battery compartment cover.
Charging the helicopter
Charging by the remote controller
Move the ON/OFF switch on the remote controller to ON. Move the
ON/OFF switch on the helicopter to OFF. Open the charger cover
on the remote controller and take out the charging cable. Insert
the charging plug into the charging socket on the helicopter. The
green charge LED on the controller will light up. The charge LED will
extinguish after approximately 1 hour to indicate the helicopter has
been completely charged.
Charging by the USB cable
Move the ON/OFF switch on the helicopter to OFF. Insert the
USB plug into the USB port on your computer. The charging
LED lights up. Insert the charging plug into the charging
socket on the helicopter. The charging LED will extinguish to
indicate the charging is in process. The LED will light up again
after approximately 1 hour to indicate the helicopter has been
completely charged.
X
X
USB charging cable
X
X
512 MB microSD card + USB 2.0 stick
with microSD cardreader
X
X
Instruction manual
X
X
Forward - Backward
X
X
Left - Right
X
X
Up – Down
X
X
Flying time: approx. 8 minutes
X
X
Charging time: max. 60 minutes
X
X
Infrared
X
X
Automatic demo flight
X
X
Camera (VGA 640 x 480 px) for video recording
and photo shootings
6 x 1,5V AA
Battery cover
9
Werbung
