Ronix RP-0800 Bedienungsanleitung Seite 26

Status
The machine
does not work
after the switch
is turned on.
When the watering
button is pressed,
there is no water
or little water
There is no dust
collection or the
suction is very
weak
|
24
Carpet Cleaner
Fault cause analysis
1-The plug is not properly
connected and
loose, resulting in poor
contact.
2-The internal line or
power cord is broken.
3-The machine set
overheats and the
protective device operates
1-The nozzle is blocked.
2-The handle or pump is
damaged.
The power switch is not
turned on.The sewage
bucket is full, causing the
floating ball to work.
The hose is abnormal.
The sewage bucket is not
installed in place.
The inlet air sponge is
blocked
Handling
Turn off the power
and plug it again.
Call the repair
telephone. Refer to
the instructions for
protective device.
Remove the water
sucker and rinse the
nozzle with clean
water. Call the repair
telephone.
Turn on the power
switch. Clean up the
sewage and use it
again. Check the hose
for cracks, breaks
and clogs. Install
the sewage bucket
properly. Clean or
replace the sponge.