Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Thank you for purchasing the PROTECTOR WLAN Power Outage
Alarm Model
SAM-1010
The power outage alarm SAM-1010 immediately alerts in case of
a power outage. It is recommended wherever it is necessary to
know immediately that a power outage occurred at the
respective device. The power outage alarm then automatically
triggers an alarm for up to 12 hours. The alarm can also be turned
off immediately by pressing the RESET button. Additionally, it
reports the alarm via a WLAN connection to the TUYA app.
COMMISSIONING
1. Plug the power plug of the device to be connected into the
socket of the SAM-1010.
2. Place the plug lock cap over the plug of the connected device
and secure it with the supplied screws to prevent accidental
unplugging. If the SAM-1010 itself is then pulled out of the
socket, the device will also report the lack of power supply.
Two different plug lock caps for all standard plugs are
included.
3. Plug the power plug of the SAM-1010 into a socket. The
socket of the power outage alarm now carries mains voltage,
the green mains power LED lights up, and the charging
process of the built-in batteries begins (initial charging time
approx. 24 hours). The connected device is now supplied with
power.
4. For safety reasons, you should perform a functional test at the
end of commissioning by briefly removing the power outage
alarm from the socket.
11
EN | SAM-1010
EN
Werbung
