MELICONI HP600 PRO Bedienungsanleitung Seite 14

If you want to continue using the headphones when the battery is low, you can supply power and recharge the batteries
at the same time by means of an ordinary charger fitted with a micro USB cable (not supplied), to be connected to USB
socket "F" on the headphones.
It is also possible to use the headphones with a direct connection to the audio source (non-wireless), by plugging the
3.5 mm jack cable into AUX socket "E".
The base unit is also equipped with a coaxial digital audio input "P". In order to connect to this, you will need a specific
cable (not supplied).
Transmission mode
Carrier frequency
RF power output
Operating voltage
Frequency response
Distortion
Signal/noise ratio
Channel separation
Maximum transmission
Headphone charging current
Headphone charging time
Headphone operating current
Integrated lithium battery
Operating temperature
Operating time of the headphones
If the headphones do not produce any sound or if the audio signal is disturbed or is presumed to come from other
sources, carry out the following steps:
1) Check that all the connections are correct and that the device is operating as described in the manual.
2) If the audio feed has been connected using an aux jack cable (3.5 mm), try increasing
the volume of the audio
3) Turn off the headphones with button "C", move closer to the base unit then turn the headphones on again, checking
if the red light "B" comes on.
4) If the problem persists, try using selector "L" on the base to change the channel (1-2-3), and press
button "C' for a moment.
read this instruction manual carefully, as it will help you solve most problems.
consult our website:
The manufacturer,
The full text of the EU Declaration
12
Istruzioni Cuffia TV HP600 PRO 14x20 05_2018.indd
Technical
UHF stereo
863.3 MHz - 863.9
< 10mW ERP
. transmitter - 5V/1A
20 Hz - 20 KHz
280 dB
dB
100 metres (in free field)
distance
200mA max.
about 2-2.5 hours
55 mA
3.7V - 420 mAh
oec to 400C
about 8 hours with a fully-charged battery, at medium volume.
Troubleshooting
source.
Helpline
If you have any queries regarding HP600 Professional:
www.meliconi.com
EU PEGLARAT'QN
Meliconi S.p.A., declares that the type of radio equipment marketed as HP600 Pro
Headphones comply with Directive 2014/53/EU
of Conformity
http://www.meliconi.com/doc/hp600pro
12
Notes
Specifications
MHz - 864.5 MHz
DC
OF CONFORMITY
(RED).
is available at the following web address:
07/05/18 11:49