iOttie Easy One Touch Wireless 2 Handbuch Seite 22

Declaration of Conformity
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment. You
can refer to the following completed FCC warnings.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received,
including interference that may cause undesired operation.
Note
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
(FCC) Operational Warnings
During the charging process, the transfer
device may become warm, but should not become exceedingly
If the device gets wet, please cease charging
plugs and dry the product completely.
dry, indoor environment.
Please be careful Of excessive drops, dents, punctures,
the device. If you are concerned,
manufacturer.
Changes Or modifications not expressly
for compliance could void the user's authority to operate
the equipment.
Operating this device in a hot environment
period Of time may cause malfunctions.
product in cooler temperatures.
Please use included components
Qi wireless charge when using a third party car charger Or a USB Power
Adapter use a minimum output Of both "9.0V-1.67A Or 5.0V-2.OA" and at least
QC 2.0.
The product's signal could possibly interfere
monitoring system). If you notice that your TPMS light turns on, please try
using your mount in different locations
with each other.
California Proposition 65 this product
state Of California to cause cancer and birth defects or other reproductive
harm.
CAUTION
OLD ELECTRICAL APPLIANCES
WITH THE RESIDUAL WASTE, BUT HAVE TO BE DISPOSED OF SEPARATELY.
of electricity gives off heat. Your
hot.
immediately. Remove all
Device is only to be operated in a
Or deformities
please unplug the device and contact the
approved by the party responsible
Or in direct sunlight for a long
We recommend keeping the
for an optimal experience. TO support
with you TPMS (tire pressure
to avoid the signals from interfering
contains chemicals known to the
MUST NOT BE DISPOSED OF TOGETHER
On