Karibu 201B Bedienungsanleitung Seite 50

No voice
Plate can be put in or
taken out, but no voice
Sound only Comes from
One speaker
The control push-button
is not available
The voice is jumping
The radio doesn't work
and can't auto select
wave band
K.4 Operation of New Style Control Panel （selected use）
K.4.1 Plug the power.
Plug the power cord into the wall outlet.
K.4.2 Turn the key ON/OFF.
Press the key ON/OFF. The Power indicator turns on.
The Temperature Display indicates the real temperature of the room. Press the key
ON/OFF again. The POWER indicator turns off.
Temperature is too high
Condensation
Volume of sound in
the lowest point
The cord is not joined well
The rear plug is not
joined tightly
Check to see if the sound
balance is set to one side
Too noisy, the
microprocessors
can't work normally
The angle of installation
beyond 30 degree
Magnetic head is dirty or
the plate has some flaws
The wire is not
connected well
The signal is too weak
- 27 -
Renew the temperature to normal level
Stop the sauna for one hour and try again
Adjust the volume as requirement
Join it well
Plug it tightly
Move the balance
The control panel is not fixed well
Fix again till the suitable position
Clean the magnetic head or change
a new plate
Connect the wire well
Select the wave band by yourself