Intex 306 Bedienungsanleitung

INTEX
Read, understand, and follow all instructions carefully before using this
• No protection against drowning. This is not a life saving device. Swimmers only.
• Do not leave children unattended while device is in use.
• Never allow diving or jumping on, onto or from this product.
• Do not exceed the maximum recommended weight capacity of 100 kg (220 lbs).
• Never slide head first or backwards. Only one user on the slide at a time.
• Make sure the water is clear and free of debris and obstructions around the slide before sliding. Keep
away from pool edge.
• Never slide, dive or jump into shallow water.
• Minimum water depth required under the product: 150 cm (59 inch).
• Do not walk or run up the slide.
• For domestic in-ground swimming pool use only. Never use in high wind, rapid currents, open water
or dangerous tides.
• Never wrap ropes around head or any other body part.
• Do not use the device if you suspect a puncture or leak.
• Not to be used while consuming or under the influence of alcohol or drugs.
• Not for white water rafting or any other extreme sports activities.
• Never use when tired or fatigued.
• Design working pressure: 0.03 bar.
• Assemble and disassemble by adults only.
• Never leave in or near the water when not in use.
Not following these rules may result in entanglement, drowning, paralysis or other serious
injury. The product warnings, instructions, and safety rules provided with the product represent
some common risks of using water recreating devices and do not cover all instances of risks
and/or danger. Always supervise and use common sense in and around water.
* For a full and complete description of each safety information symbol and safety sign printed on the
product and the packaging please refer to the "Definition" section or sheet.
General
• Two or more adults are recommended for setup. No tools are required for the assembly.
Keep product centered in the pool: it is recommended to use two ropes (not included) of more than 4 m
(158 in) long each to keep the product from drifting to the pool edge during use.
• Locate the slide out of direct sunlight to reduce the likelihood of scalding. A product that faces north will
receive the least direct sunlight. Splash with water prior to using.
• Do not modify this product and/or use accessories not supplied by the manufacturer. There are no
serviceable parts.
• There are two self-bailing holes located on the floor to prevent water from accumulating. Check that the
main raft has completely drained before slowly removing from the pool.
• Take off watches, rings and other sharp objects before use. Do not use in darkness.
Inflating Instructions
1. Locate a clean area free of stones or other sharp objects.
2. Adults should inflate all components and air chambers on the raft slowly with a foot or manually
operated air pump. Make sure the device is firm to the touch but not hard. If there is any sign of
straining at the seam, the product is over-inflated. If any seam begins to strain, immediately stop the
inflation and release air to reduce the pressure until signs of stress on the seam are gone.
CAUTION: To prevent bursting, do not over inflate, use high pressure air compressor or exceed the
recommended design working pressure. Fill with cold air only. Monitor inflation level as the ambient
temperature increases releasing air as necessary.
SAVE THIS INSTRUCTIONS
® OWNER'S MANUAL
product. Keep for future reference.
WARNING
(306) ENGLISH 4.875" X 7.25" 05/02/2018
306-*IO-R0-1905
306 306