Know Your Product; Operation Mode Selection - Status Mpr26 Originalbetriebsanleitung

KNOW YOUR PRODUCT

OPERATION
• The tool must be used only for its prescribed purpose. Any use other than those
mentioned in this Manual will be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury resulting from such cases of
misuse.
• To use this tool properly, you must observe the safety regulations, the assembly
instructions and the operating instructions found in this Manual. All persons who use
and service the machine have to be acquainted with this Manual and must be informed
about its potential hazards. Children and frail people must not use this tool. Children
should be supervised at all times if they are in the area in which the tool is being used.
It is also imperative that you observe the accident prevention regulations in force in
your area. The same applies for general rules of occupational health and safety.
• The manufacturer shall not be liable for any changes made to the tool nor for any
damage resulting from such changes.
Even when the tool is used as prescribed it is not possible to eliminate all residual risk
factors. The following hazards may arise in connection with the tool's construction and
design:
• Damage to hearing if effective ear defenders are not worn.
• Power tools must not be used outdoors in rainy weather, or in moist environment (after
rain) or in close vicinity with easily flammable liquids and gases. The working place
should be well lit.
KNOW YOUR PRODUCT
1. SDS plus socket
2. Operation mode selector switch
3. Forward/reverse switch
OPERATION

OPERATION MODE SELECTION

Switching between the operation modes shall be performed only when the machine is
turned off.
Turn the mode selector switch (2) to the necessary position.
• Drilling - drilling in metal, wood, plastics, etc.
• Hammer drilling - hammer drilling in concrete, stone, etc.
• Hammer mode - chiselling grooves and demolishing in concrete, masonry, etc.
• Adjusting the chisel - to avoid operator's fatigue, insert and fix the chisel in the
necessary position.
EN
4. ON/OFF trigger switch
5. Lock-on button
6. Additional handle
6