VEVOR RB48-8-5 Bedienungsanleitung Seite 4

Step 2
Using a stud finder to locate the studs.
Step 3
Place mounting board onto the wall and use level to make sure the
mounting board is LEVEL.
Step 4
Use a drill bit to pre-drill holes through the mounting board to the wall.
Step 5
Install anchors. Use anchors A for cement or brick wall. Use anchors B for
dry wall. If studs are present, no wall anchors are needed.
Step 6
Attached the mounting board to the wall with the long screws. Check
again if the mounting board is installed level.
Step 7
Place mantel shelf on the mounting board.
Step 8
- 3 -