Ronix 4010 Bedienungsanleitung Seite 29

Sufficient pressure
cannot be applied to
the cutter.
Pressure yokes fall
out.
Poor cutting
SHEEP SHEARING HEAD
MALFUNCTION
Does not cut.
Shearing head gets very hot.
The tension link is broken.
The sliding sleeve missing.
The sliding sleeve is worn
down.
Swiveling fork is worn down on
top.
Pressure yokes are worn down.
Securing lugs on tension link
spring.
Comb and cutter blades are
blunt.
The shearing blade tension is
too low.
The blades were not properly
sharpened.
CAUSE
The comb plate was wrongly
fitted.
Crank roller missing.
Cogwheel and/or reducing
Shearing head wore out.
The shearing tension is too
high.
No lubricant film on the crank
roller.
No grease on the sliding
sleeve.
Bearings are worn out.
Have the tension spring replaced.
Replace the sliding sleeve.
Replace the sliding sleeve.
Have swiveling fork replaced.
Have pressure yokes been
replaced.
Have the tension link spring
replaced
Have re-sharpened with approx.
20µm negative crown.
Increase pressure by tightening
the tension nut.
Have re-sharpened with
approx.20µm negative crown.
RECTIFICATION
Readjust the upper blade 1.5
mm backward in relation to
the comb plate.
-
Replace cogwheel.
-
Reduce shearing tension and
have blades
re-sharpened if necessary.
Oil and roller
Grease sliding sleeve.
-
User Manual
27