Bionik VULKAN Bedienungsanleitung Seite 10

will automaticallu
WIRELESS
l. Move the mode selection switch to the PC icon (FIG. 3).
2. Gently remove the battery cover on the back of the VulkanTMand
remove the wireless dongle (FIG.1).Replace the batteru cover.
Insert the wireless dongle into an available USB-A port on gour PC
3. Press the home button once. The home LED will flash orange. The
wireless dongle will automaticallu
paired, the home LED will be a solid orange.
WIRED pc CONNECTION
1. Move the mode selection switch to the PCicon (FIG.3).
2. Uncoil the included Micro-USB
as gou unwind it.
3. Gentlu insert the Micro-IJSB end of the cable into the Micro-USB
port at the top of the VulkanTM(FIG.4). Gentlg insert the USB-A end
of the cable into an open USB port on your PC.
4. The VulkanTM will automaticallu
be a solid white.
NOTE: The VulkanTM does not require batteries while connected
via cable.
BUTTON MAPPING
l. Turn the button mapping feature on bu moving the center switch
on the customization panel down (FIG 5).
2. For each paddle, move the mapping slider to the button that you
would like to map the paddle to (FIG.5).
3. To turn the button mapping feature off, move the center switch on
the customization panel up (FIG.5).
SWAPPING
l. Centlu unscrew the cap of the joustick counterclockwise (FIG 6A).
2. Centlu screw in the selected replacement cap clockwise until it is
secure (FIG.6B). WARNING: Do not overtighten joustick caps.
SLEEP MODE
l. To conserve batteru, wireless pairing mode for both AndroidW and
PCwill shut off after 2 minutes of inactivity; once paired, the
VulkanTM will shut off after 10 minutes of inactivity.
re-pair to your device.
PC CONNECTION
THE REAR
THE JOYSTICK
WITH DONGLE
pair with the VulkanTM. Once
WITH CABLE
cable. Gently straighten the cable
wake up paired; the home LED will
PADDLES
CAPS
-9-