UGREEN NASync DXP6800 Pro Benutzerhandbuch Seite 9

4. Peel off the protective film of the silicone pad and stick it on the front-facing
peel off the film on the other Side
5. Renstall the panel and power on the NAS. After successful boot up, go to the "UGREEN NASI' app to
set the SSD cache
AWarning
To avoid data loss, please remove the SSD cache in the "UGREEN NAS" before
removing any M.2 SSD. This will provide added protection
is using it for caching.
surface of the SSD, then
in case the system
Installing Memory Modules
Power off the NAS device, then turn it over Loosen the screws and remove the bottom panel.
2 Align the notch on the pins of the module
into the slot and gently push it down to ensure the module
3. Reinstall the panel and tighten the screws.
2
with the corresponding ridge in the slot. Insert the module
is properly Inserted.
3
12