eichhorn Junior Rider Plus Gebrauchsanleitung Seite 14

Connect to the pram/buggy/stroller/trolley:
1. When the board is in a horizontal position, screw the parts together tightly
and tighten the retaining straps of the coupling to the axle strut of your stroller.
2. Place the retaining straps as far apart as possible; the coupling plate (6) can be
infinitely adjusted in width for this purpose. Tighten the nuts firmly to fix the width
adjustment (image B).
IMPORTANT: The fixing connector loops must be tightened
very tightly to the frame of the stroller/buggy,
they must no longer be able to move or rotate!
The Rider can tip over if it is attached too loosely!
To release the connection, press the relevant button to pull out the loop and remove
the coupling from the axle (image C).
Done!
Your Junior Rider Plus is now ready to ride.
C
A
B