Outsunny 845-949V02 Montageanleitung
Quicklinks
Verwandte Anleitungen für Outsunny 845-949V02
Inhaltszusammenfassung für Outsunny 845-949V02
- Seite 1 IN231100744V01_GL 845-949V02...
- Seite 2 ① ② ③ ④ ⑤ ⑦ ⑧ ⑨ ⑩...
- Seite 3 60mm 35mm NOTE EN_Do not confuse similar screws.Do not tighten bolts fully until all parts are connected! FR_Ne pas confondre des vis similaires.Ne serrez pas les boulons à fond tant que toutes les pièces ne sont pas connectées! ES_No confunda tornillos similares.No apriete los tornillos completamente hasta que todas las partes están conectadas! PT_Não confundir parafusos semelhantes.
- Seite 4 EN_Assemble four curved supports with longer bolts (Insert for preliminary fixation only, and tighten later). FR_Assembler les quatre supports courbes avec des boulons plus longs (les insérer pour une fixation préliminaire seulement, et les serrer plus tard). ES_Monte cuatro soportes curvos con pernos más largos (insértelos sólo para la fijación preliminar y apriételos después).
- Seite 5 EN_Put two floor supports(short) and two horizontal supports'(long) together. FR_Assembler deux supports de sol (courts) et deux supports horizontaux (longs). ES_Junte dos soportes de suelo (cortos) y dos soportes horizontales (largos). PT_Juntar dois suportes de chão (curtos) e dois suportes horizontais' (compridos). DE_Legen Sie zwei Bodenstützen (kurz) und zwei horizontale Stützen (lang) zusammen.
- Seite 6 60mm 35mm EN_ Assemble parts 1,2,3,4 and 5 into a rectangle as shown in the figure below. No.7 and No.8 should be used on the same side. Pay attention to the direction of No.7 and the direction with the shrinking tube upward. Connect No.9 is shown in the figure below. Note that the pipe head should be placed in the middle of the two pipes.
- Seite 7 60mm...
- Seite 8 60mm...
- Seite 9 EN_ The structure of this part is shown in the figure. Be sure to install it in the order shown in the figure. Keep the joint of the steel pipe within the range of the black cylindrical part, and make the translucent silicone gasket closely fit the black cylindrical part and lock it tightly (in case of water leakage, Please disassemble the nut again and check if the silicone gasket is installed in place).