Buffalo HX583 Bedienungsanleitung Seite 5

Blending
Before use, ensure to:
• Disconnect blender from the power supply.
• Clean all removable parts thoroughly and dry well.
1. Connect blender to the power supply.
2. Place ingredients into jug.
3. Secure the lid and lid plug.
4. Locate jug onto the motor base and close the sound enclosure. The power button will flash.
5. Press the power button to enter Standby and all buttons will light up.
6. Select a desired mode to start blending.
7. The blender will turn off automatically when the set time expires.
8. Disconnect from power supply after use.
• Note: Equipped with an interlock switch, the blender will stop automatically when the
sound enclosure is opened.
• To avoid overheating or damage, do not let the appliance run at the MAX speed
continuously for more than 2 minutes. Afterwards, ensure to let it rest for 2 minutes.
• Let the motor come to a complete stop before removing the jug.
Wave mode
Wave mode is a pre-set program designed to alternate between low and high speeds for 30 seconds. It is
possible to adjust the program time length by following the instructions below.
1. Press and hold "P" until the display shows "DIY" with 1 beep sound.
2. Press the timer buttons to adjust timer from 1s to 300s. (Speed cannot be adjusted in this mode.)
3. Press "P" to save the settings or press the power button to cancel.
Low speed mode
DIY setting:
1. Press and hold "L" until the display shows "DIY" with 1 beep sound.
2. Press the speed buttons to adjust speed from level P1 to P9 and press the timer buttons to adjust
timer from 1s to 300s.
3. Press "L" to save the settings and return to Standby, or press the power button to cancel.
Medium speed mode
DIY setting: Refer to the DIY settings for the low speed mode.
S1 mode
Default setting: Press "S1" to run the pre-set program at speed level P13 for 60 seconds.
DIY setting:
1. Press and hold "S1" until the display shows "Sp:0" and "0:00" with 1 beep sound. For this program, a
total of 6 stages can be set.
2. Press the speed buttons to adjust speed from level P1 to P25 and press the timer buttons to adjust
timer from 1s to 300s. Then press "S1" to confirm and set Stage 2.
3. Repeat step 2 to set for stages 3, 4, 5, and 6.
4. Press "S1" to save the settings and return to Standby.
S2 mode
Default setting: Press "S2" to run the pre-set program at speed level P3 for 25 seconds.
DIY setting: Refer to the DIY settings for the S1 mode.
HX583_ML_A5_v1_20241008.indb 5 HX583_ML_A5_v1_20241008.indb 5
High speed mode
EN
5
2024/10/8 15:28 2024/10/8 15:28