GRAPHITE 58GE100 Übersetzung Der Originalanleitung Seite 15

Electricity Input
Ignition
Primary Flame Thermal Probe Operated Gas Valve
Control
Overheating
Protection
Destination AT,BE,CH,CZ,DE,DK,ES,FI,FR,GR,HU,I
countries E,IT,LT,LV,LU,NL,NO,PL,PT,RO,SE,SK,
Insulation Grade
Safety distances
WARNING! To ensure safe work, always keep a safe
distance:
GENERAL INSTRUCTION
•
The heaters mentioned in this manual must only be used
outdoors or in well ventilated surroundings.
•
For every KW it is necessary to have permanent ventilation
of 25cm³, equally distributed between the floor and high
level, with a minimum outlet of 250cm³.
•
Gas cylinders must be used and kept in accordance with
current regulations.
•
Never direct the hot air flow towards the cylinder.
•
Use only the supplied pressure regulator.
•
Never use the heater without its cover.
•
Do not exceed 100W/m³ of free room. The minimum
volume of the room must be larger than 100m³.
•
Do not obstruct the inlet or outlet sections of the heater.
•
If the heater has to work for a long period at its maximum
capacity, it's possible that ice will form on the cylinder. This
is due to excessive vapour withdrawal. Not for this reason,
or for any other, should the cylinder be heated. To avoid
this effect, or at least to reduce it, use a large cylinder or
two cylinders linked together
Do not use the heater in cellars, basements or in any room
below the ground level.
In case of malfunction, please contact the technical assistance
service.
After use, turn the gas cylinder tap off.
The gas bottle must always be replaced following safety rules
away from any possible source of ignition.
The gas hose must not be twisted or bent.
The heater must be placed where there is no risk of fire, the hot
air outlet must be at least 3m from any flammable wall or ceiling
and must never be directed towards the gas bottle.
Only use original gas hose and spare parts.
Heaters described in this leaflet are not intended for domestic
use.
In the case that a gas leak is found or suspected, immediately
close the gas cylinder, switch the heater off and do not use it
again until it has been checked by a qualified service centre. If
the heater is installed indoors, provide a good ventilation by
18 V DC
piezo
75℃/95℃
UK
II
opening door and windows completely. Do not produce sparks
or free flames.
If in any doubt contact your supplier.
INSTALLATION
Connect the heater to the battery DC18V
Make sure that the machine is properly earthed.
Connect the gas supply hose to the pressure regulator and
connect the regulator to a suitable LPG cylinder.
Open the tap of the cylinder and check the supply hose and
fittings for gas leak. For this operation it is recommended to use
an approved leak detector.
NEVER USE NAKED FLAMES.
For automatic appliances, connect the room thermostat to the
socket on the appliance and adjust it to the required
temperature.
INSTRUCTION FOR USE
PREPARING FOR OPERATION
•
Check the heater for possible shipping damage.
•
Connect the hose and regulator assembly to the LPG
cylinder by rotating the nut counterclockwise into the LPG
cylinder's valve outlet and securely tighten.
•
Open the cylinder's gas valve and check all gas
connections with a soap and water solution.
•
Connect power cord to use the battery DC18V
IGNITION / Manual ignition
Turn the power switch to position ON and check that the fan
starts running correctly.
Push the gas valve button and push repeatedly the piezoelectric
lighter until the flame lights up.