Quax Intelligent potty Kurzanleitung Seite 7

ENGLISH
1. Instructions for the recording module
Removing the recording module from the potty.
Take the module between your thumb and forefi nger and push the sides. Turn the module to the left and take it out of the
toilet. To replace the module, work the other way.
Placing the batteries in the recording module.
How to make a recording ?
Press the record button (REC). Keep it constantly pressed and release the button after recording. Maximum duration is
six seconds.The recorded message starts playing and the recording module is ready for use.
The recording module is not working ?
Failure to activate the sound may be due to :
• The child does not sit on the toilet
• There is no suffi cient amount of liquid in the inner pot, too little peed. There is a minimum of 40-50 ml of fl uid needed
in the inner potty
• The inside and outside of the inner pot are still moist
• The sensor plates on the module are not dry
By
Quax nv - Karel Picquélaan 84 - B-9800 Deinze - Belgium - T +32 9 380 80 95 - E info@intelligentpotty.com - W www.intelligentpotty.com
The battery compartment is located underneath the recording module and is covered
with a lid (A). Release the screw (A1), remove the lid and place the three batteries
(AAA). Close the battery compartment and refasten the screw.
Batteries are not included.
The module will only work properly when functioning AAA batteries are inserted and
replaced in time.
7