Werbung
OPTIONS AND FUNCTIONS
OPTIONS can be selected directly by pressing the corresponding button (see CONTROL PANEL).
If an option is not compatible with the selected program see PROGRAMS TABLE, the corresponding LED flashes rapidly 3 times
and beeps will sound. The option will not be enabled.
PUSH&GO
Push&GO button is an easily distinguishable button that allows
you direct access to the Push&GO program, a wash and dry cycle
that ensures great cleaning performance in a short time. You
don't have to worry which program to choose, Push&GO cycle
will do the work for you.
To select Push&GO program, switch on appliance, press only
Push&GO button for 3 seconds and close the door within
4 seconds.
DELAY
The start time of the program may be delayed for a period
of time between 1 and 12 hours.
1. Press the DELAY button: the corresponding «h» symbol
appears on the display; each time you press the button,
the time (1h, 2h, etc. up to max. 12h) from the start
of the selected wash cycle will be increased.
2. Select the wash program, press the START/Pause button
and within 4 seconds close the door: the timer will begin
counting down.
3. Once this time has elapsed, the indicator light «h» switches
off and the wash cycle begins.
To adjust the delay time and select a shorter period of time,
press the DELAY button. To cancel it, press the button repeatedly
until the selected delayed start indicator light «h» switches off.
The wash program will start automatically as soon as the door
is shut.
The DELAY function cannot be set once a wash cycle has
been started.
TABLET (Tab)
This setting allows you to optimize the performance
of the program according to the type of detergent used.
START/Pause
Press the
symbol will light up) if you use combined detergents in ta-
blet form (rinse aid, salt and detergent in 1 dose).
If you use powder or liquid detergent, this option should
be off.
4
button for 3 seconds (the corresponding
EXTRA
EXTRA makes it possible to carry out a heavy-duty wash cycle
of large crockery up to a max height of 53cm: baking pans,
oven grids, dripping pans, hob grids, large saucepans, serving
dishes, pizza dishes, stainless-steel hood filters.
Remove the upper rack to load bulky crockery.
AUTO DOOR
Auto Door is a convection drying system which automatically
opens the door during/after drying phase to ensure exceptio-
nal drying performance every day. Door opens at the temperature that
is safe to your kitchen furniture.
As additional steam protection, special designed protection foil is added
together with the dishwasher. To see how to mount protection foil
please refer to (INSTALLATION GUIDE).
Auto Door functionality could be disabled by the user as follows:
1. Go to the Dishwasher software menu pressing and holding P
button (6 sec).
2. You switched to Auto Door Control Menu, you could change status
of Auto Door functionality by pressing P button:
E – enabled
d – disabled
To confirm the change and exit from the Control Menu please press
and hold P button (3 sec).
Release the two locks (right and left)
and pull out the rack.
When the upper rack is fitted,
the locks must be always closed.
In order for the water to reach
the crockery everywhere, arrange
it as shown in the Figure.
Do not start the dishwasher
without the upper rack using wash
cycles other than EXTRA.
To carry out the wash cycle Extra
pour the detergent DIRECTLY INTO
THE TUB and not into the dispenser.
Werbung
