Konig CMP-RCT31 Anleitung Seite 5

Remote test
• Plug one end of the to be tested cable into the sourcing RJ45 jack ( marked with " ") of
the master unit and the end of the cable to the receiving RJ45 jack of the remote unit. If
the to be tested cable is already installed on the patch panel or wall plate, you can use
the adaptor cable to solve the connector gender problem.
• Switch to auto mode when you are performing this test alone. This way the tester will
automatically test all the wires inside the cable, without you needing to push the buttons
on the remote unit.
• Read the test result from the LED display on the remote unit.
Note: The LED display indicates the wires in the same sequence in auto mode as in
manual mode.
Patch Panel
Remote Test
5
Wall Panel