Renkforce RF-SW-110 Bedienungsanleitung Seite 4

• Recording timings can be viewed while the stopwatch is still timing or has been stopped.
To do this, press the S2 key; RECALL will temporarily be displayed, followed by the first
recording on the upper row and the total time on the lower row. Press the S2 key again to
display subsequent recordings up to a total of ten recordings. After all the recordings have
been displayed, press the S2 key again and RECALL will be disappear. The stopwatch
timer can continue while you are viewing recordings. Press the S1 key to stopped the timing
(displaying STOP on the screen), then press the S3 key to reset the stopwatch. When the
stopwatch has been reset, previous recordings can still be viewed until the stopwatch is
started again.
• To view the fastest (FS), slowest (SL) and average (AV) recorded times while the stopwatch
is still timing or has been stopped. To do this, press S2 key; RECALL will temporarily be
displayed, then press the S1 key to display the average (AV), and press S3 to display the
fastest (FS), slowest (SL) on the upper row. Press the S1 key to stop the timing (displaying
STOP on the screen), then press the S3 key to reset the stopwatch. The recordings will then
be automatically cleared upon subsequent use.
3. Countdown
• Press the S2 key to select cycle countdown (displayed as 01) or countdown first and then
stopwatch (displayed as 02).
• For cycle countdown (01), press the S3 key and then set the required hours, minutes
and seconds for the countdown timer using the S1 key. Press the S3 key to confirm the
countdown timer value and press the S1 key to start the countdown with a short beep
alarm. While setting the countdown timer, the stopwatch can continue to be used. When
viewing stopwatch recordings, the countdown timer will be displayed in the upper row and
the number of times in the lower row.
• For countdown first and then stopwatch (02), press the S3 key and then set the required
hours, minutes and seconds for the countdown timer using the S1 key. Press the S3 key
to confirm the countdown timer value and press the S1 key to start the countdown with a
short beep alarm.
• When complete the countdown, it will automatically start the stopwatch.
4. Metronome
• To set the metronome tempo, press the S3 key to choose either 10, 20, 30, 40, 60, 80, 120,
160, 240 or 320 beats per minute and press the S1 key to confirm.
• The tempo will be sounded with short beeps.
• Press the S1 key to stop the tempo and press the S3 key to reset the beats per minute.
5. Alarm clock
• Press the S2 key to select one of the four alarms (AL1, AL2, AL3 and AL4), and then press
the S3 key to select the ON/OFF time. Press the S1 key to set the hour and minute value of
the alarm time, and then press the S2 key to confirm the alarm, which will be confirmed by a
short beeping sound. When any alarms are set, the clock icon is displayed.
Care and cleaning
• Disconnect the product from the mains before each cleaning.
• Do not use any aggressive cleaning agents, rubbing alcohol, or other chemical solutions as
they can cause damage to the housing and functioning of the product.
• Clean the product with a dry, fibre-free cloth.
Disposal
a) Product
This symbol must appear on any electrical and electronic equipment placed on the
EU market. This symbol indicates that this device should not be disposed of as
unsorted municipal waste at the end of its service life.
Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose
of it separately from unsorted municipal waste. Spent batteries and accumulators,
which are not enclosed by the WEEE, as well as lamps that can be removed from
the WEEE in a non-destructive manner, must be removed by end users from the
WEEE in a non-destructive manner before it is handed over to a collection point.
Distributors of electrical and electronic equipment are legally obliged to provide free take-back
of waste. Conrad provides the following return options free of charge (more details on our
website):
• in our Conrad offices
• at the Conrad collection points
• at the collection points of public waste management authorities or the collection points set
up by manufacturers or distributors within the meaning of the ElektroG
End users are responsible for deleting personal data from the WEEE to be disposed of.
It should be noted that different obligations about the return or recycling of WEEE may apply in
countries outside of Germany.
b) (Rechargeable) batteries
Remove batteries/rechargeable batteries, if any, and dispose of them separately from the
product. According to the Battery Directive, end users are legally obliged to return all spent
batteries/rechargeable batteries; they must not be disposed of in the normal household waste.
Batteries/rechargeable batteries containing hazardous substances are labelled with
this symbol to indicate that disposal in household waste is forbidden. The abbrevi-
ations for heavy metals in batteries are: Cd = Cadmium, Hg = Mercury, Pb = Lead
(name on (rechargeable) batteries, e.g. below the trash icon on the left).
Used (rechargeable) batteries can be returned to collection points in your municipality, our
stores or wherever (rechargeable) batteries are sold. You thus fulfil your statutory obligations
and contribute to environmental protection.
Batteries/rechargeable batteries that are disposed of should be protected against short circuit
and their exposed terminals should be covered completely with insulating tape before disposal.
Even empty batteries/rechargeable batteries can contain residual energy that may cause them
to swell, burst, catch fire or explode in the event of a short circuit.
Technical data
Functions ...................................... Stopwatch, countdown timer, metronome, clock, alarm
Battery type .................................. CR2032 (included & installed)
Timer accuracy ............................. 0.01 seconds (1/100 seconds)
Display layout ............................... 2 rows
Time format .................................. 12/24 hours
Operating/storage conditions ........ 5-40 °C (operating temperature)
0-40 °C (storage temperature)
10-85% relative humidity (non-condensing)
Dimensions ................................... 82 x 61 x 17 mm (L x W x H)
Weight .......................................... 108 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights in-
cluding translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication
represent the technical status at the time of printing.
Copyright 2021 by Conrad Electronic SE. *2306490_v5_0224_02_DS_m_2L_(1)