Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Functions:
Adjustments:
To operate the radio controlled outlets with the remote control the channels for transmitting and receiving
signals on all participating devices must be adjusted. Furthermore all participating radio controlled outlets must
be allocated to a pair of keys on the remote control to switch them on and off.
For this purpose you can find switches on the remote control. The transmitters can be trained by a switch and
save up to 10 codes.
The Training of the Receivers:
Use the coding selector [3] at the remote control to choose the desired coding.
Plug the receiver to an electric outlet and switch it on.
If the receiver has not yet saved any code then its LED flashes now and shows that the device is ready
for code-learning.
Choose any key pair of the channel buttons [2] and press ON or OFF.
When the LED of the receiver stops flashing the code-learning is done. Now it is possible to control this
receiver with its corresponding key pair at the remote control.
If the receiver has stored another code already its LED will not flash when it is connected to an electric
outlet.
However to make it ready for code-learning press its indicator button. Hereupon the LED starts flashing.
Now choose any key pair of the channel buttons [2] and press ON or OFF.
When the LED of the receiver stops flashing the code-learning is done. Now it is possible to control this
receiver with its corresponding key pair at the remote control.
No.
1
2
3
4
ETT Distribution GmbH Schmalbachstraße 16 38112 Braunschweig
Nachdruck oder Vervielfältigung nur mit ausdrücklicher Genehmigung
Beschreibung
LED as operation display
Channel Button (ON/OFF) and
dimmer. Training function for
receiver
Coding selector
ALL-ON/ALL-OFF switch for
turning all receiver on or off at
once
534-700
Werbung
