Maintenance - Hama 00040617 Bedienungsanleitung

00040617bda 15.03.2006 12:42 Uhr Seite 10
base stations coverage area. You can install the
repeater at a location, in the edge of the coverage
area, where you still have a good connection bet-
ween the handset and the base station. A new
coverage area will now be available around the
repeater.
Note: The LED must remain on constantly after the
device has been switched on.
If the LED flashes, the repeater is too far away from
the base station or reception is being hindered by
thick walls or metal objects (e.g. radiators)
Verification tone
The verification tone enables you to establish
whether or not the mobile unit is working in the
extended area of the repeater. This tone is audible
on the activated mobile unit as long as the unit is
connected to the repeater.
Carry out the procedure described below on your
repeater in order to switch the verification tone on
and off:
- Switch off the unit (disconnect the power plug)
- Switch on for 1-5 seconds and switch it off again.
- Switch on again. The LED on the unit is flashing
slowly, switch off again.
- Switch it on again. The verification tone is then
activated or deactivated.

Maintenance

Simply wipe the repeater with a damp cloth or an
antistatic wipe.
Never use solvents or a dry cloth (static discharge).
Automatic Registration
Base station
Switch on
Basestation
Press Registration
Page key
Repeater
Switch on
Repeater
LED flashes
Repeater
LED steady on
Ready for use
Manual Registration
Base station
Switch on
Repeater
Switch on/off
Switch on again
Base station
Press registration/
Page key
Repeater Repeater
No
Quick flashing Quick flashing
with brief
No interruptions
Interruptions
Handset
Yes
Registration of
handset PIN=0000 Ref.
user manual
Repeater
Handset
Hook off key Quick flashing no
interruptions
Repeater
LED steady on
Handset
Enter RPN-No.
Between 2 and 7
Handset
Press * Hook on key
Ready for use