Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
4.
5.
Fixing the L-Connector:
Use the same method as for the power supply cable (description above)
Fixing the Middle-Connector:
Use the same method as for the power supply cable (description above)
Fixing 2 ends together with the Splice Connector:
1. First slide the heatschrink over one of the Neonflex tubes.
Insert the connector pins in one of the Led Neonflex tubes and press both tubes together.
2. Apply silicon glue to fill up the gap between the two Neonflex tubes.
3. Cover with the heat shrinkable tube and shrink with a heat-blower.
1.
2.
Fixing the end cap:
1. Add silicon glue to the end cap
2. Place the end cap over the Led Neonflex tube.
1.
2.
Fixing the Led Neonflex with the alu mounting strips:
The ALU strips are sold in 1meter lengths: you can cut these to the size you like.
First fix the alu strips to the wall, then you can place the Neonflex tube inside.
For curved installations, you can use smaller parts of the alu strip.
Warning: never bend the Led Neonflex with a diameter that is inferior to 40mm !
BRITEQ
®
OPERATION MANUAL
6.
3.
3/24
LED NEONFLEX
ENGLISH
OPERATING INSTRUCTIONS
Once connected to the mains the device starts running.
Always unplug the unit when it is not used for a longer time or before start servicing.
In the event of serious operating problems, stop using the fixture and contact your dealer immediately.
SPECIFICATIONS
Mains Infput
Roll length
LED spacing
Total n° of LEDs
Total Watts
Watts per Meter
Color
Light output (Lm / m)
N° of leds per unit
Unit length for cutting
Max loading length
with 1.6A power cord
Every information is subject to change without prior notice
You can download the latest version of this user manual on our website: www.beglec.com
BRITEQ
®
OPERATION MANUAL
AC 230V, 50Hz
50,29m
0,5"
3960
198W
4 W/m
Red
Blue
8,34
4,8
120
72
1,52m
0,91m
97m
96m
4/24
LED NEONFLEX
Werbung
