Technical Specifications; Safety Functions; Function Description; Cleaning Notes - Lenz heat bag 1.0 Bedienungsanleitung

heat bag 1.0
O p e r a t i n g I n s t r u c t i o n

TECHNICAL SPECIFICATIONS

heating mat 240VAC: 240V~ / 50Hz 90W
heating mat 12VDC: 12V

SAFETY FUNCTIONS


Overheating protection

Temperature control

FUNCTION DESCRIPTION

• For preheati g a d drying of shoes, gloves, socks, hats and other textiles.
IMPORTANT INSTRUCTIONS FOR USE
Attention:

The heat mat 12VDC must be placed above the 240VAC heating mat, to get best
heating performance.

It is not allowed to use the 240VAC heating mat and the 12VDC heating mat(car) at
the same time.

During operation, ensure that the ventilation openings at the top of the bag not be
covered.

Do not place products in the heatbag, if not suitable for temperatures above 55°C.
(read warning notes on the products)

Remove snow, ice, water and dirt from the products, before place into the
heatbag.
 Always disco ect the u it fro the power supply whe the e gi e is 't ru
OPERATING
Place the products in the heat bag and close the zip.
Connect the heating pocket to the 240VAC mains.
The heat effect will start after ½ hour, after another few hours the products are warmed up. (overnight)
Before further use of the heater bag in the car, first disconnect the heat bag from the 240VAC mains,
only then connect to the 12V car power.

CLEANING NOTES

The mats must be disconnected from the mains.
Remove the heating mats from the heat bag before cleaning.
Use damp cloth only for cleaning the heat bag.
/ DC 50W (Car Version)
Seite 3/4
E N G L I S C H
i g.