Maintenance And Cleaning; Technical Data - Renkforce X7CD Bedienungsanleitung

Maintenance and cleaning

Caution! The cutting knives are very sharp. Risk of injury.
• Turn off the product and disconnect it from the power outlet before cleaning.
• Never submerge the product in water.
• There are no components located inside the product you need to maintain. Never
open/dismantle the product.
• Empty the collection containers regularly.
• Under no circumstances use aggressive cleanings agents, cleaning alcohol or other
chemical solutions since these can penetrate the housing or impair functionality.
• To clean the product, a dry, soft and clean cloth is sufficient. Do not apply too much
pressure to the housing as this may cause scratch marks.
• From time to time (after approx. 200 shredding procedures), use a special, non-
flammable shredding oil in order to lubricate the cutting tools. Spraying bottles and
special oilpaper are available in specialist shops.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste.
Dispose of the product at the end of its life span in accordance with the
respective statutory regulations.
You thus fulfill your statutory obligations and contribute to the protection
of the environment.

Technical data

Operating voltage/current .................230 – 240 V/AC, 50 Hz, 1.2 A
Protection class ..................................II
Type of cutting .....................................Cross cut (paper)
Input slot width ....................................220 mm (paper)
Cutting size ...........................................4 x 45 mm (paper)
Cutting speed .......................................2.3 m/min
Amount of sheets ................................max. 7 (at 80 g/m
Container capacity (paper)................15 l
Operating time .....................................2 min ON / 60 min OFF
Noise level............................................≤74 dB
Safety level...........................................3 (DIN 32757)
Cable length .........................................approx. 1.4 m
Operating/storage conditions ...........0 to +35 ºC, 20 – 85 % RH
Dimensions (W x H x D)......................392 x 335 x 280 mm
Weight ...................................................3.8 kg
)
2
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represents the
technical status at the time of printing.
© Copyright 2016 by Conrad Electronic SE. V1_0216_02-HK