Heitronic MAGIC Installations- Und Bedienungsanweisung Seite 2

GB Installation and operating instructions
LED battery-powered table luminaire MAGIC
Art. No. 501433
These operating instructions belong exclusively to the product. It contains important information on the commissioning and
handling of the light. Therefore, please pay attention to these operating instructions, even if you pass this product on to third
parties. Please keep these instructions in a safe place for future reference.
1.
Introduction
Dear customer, thank you for purchasing our product. You have purchased a product from LDBS, which has been built according to
the current state of the art. The luminaire meets the requirements of the applicable European and national directives. In order to
maintain the condition of the product and to ensure safe operation, you as the user must observe these operating instructions!
2.
Safety instructions

In case of damage caused by non-observance of these operating instructions, the warranty claim expires!

We do not assume any liability for consequential damages!

Do not bring the lamp into contact with extreme heat or open flame.

We accept no liability for damage to property or personal injury caused by improper handling or non-observance of the safety
instructions.

In such cases, all warranty claims are void.

The entire product must not be modified or converted. Modifications to the product will void the warranty.

The type plate must not be removed.
3.
Intended use

The luminaire is designed for indoor use.

Make sure that the lamp is always standing level on the ground to prevent it from falling over.
4.
Start-up and running time

Carefully remove the lamp from its packaging.

There is no possibility to change the illuminant

There is no possibility to change the battery

Charge the lamp (see point 6 Charging the lamp and runtime).

Switch the light on and off by touching the switch on the underside of the light.
- 3 modes: 100% / 50% / automatic dimming (slow, dimming up and down 10- 100%).
- Lighting duration: 100% approx. 5 hours, 50% approx. 11 hours, automatic dimming approx. 8
hours.
5.
Malfunctions
Lamp does not switch on or switches on only briefly.

Lamp switched on?

Low battery Charge the lamp with a USB cable and an appropriate USB plug-in power supply.
6.
Charging the luminaire
The connection socket is located at the base of the light. Connect the USB-C plug to the light here. The charging time of the light
depends on your power supply unit (maximum 1A), the average duration is approx. 3-4 hours. During charging, the socket lights up
red; when charging is complete, the socket lights up green.
7.
Technical data
Article
USB-C ; 1x 2000 mAh, 3,7 V
501433
Li-Ion battery, not changeable
8.
Care

For cleaning, use a dry cloth.

Never use chemicals or abrasive cleaners for cleaning.

The luminaire must be cleaned of dirt at regular intervals.
9.
Disposal

Waste electronic equipment must be taken to public collection points and must not be disposed of as household waste.

Batteries/rechargeable batteries must not be disposed of as household waste. As the end user, you are legally obligated to
return used batteries. You can return batteries free of charge after use to the point of sale or in its immediate vicinity (e.g. at
municipal collection points or in shops).
LDBS Lichtdienst GmbH ǀ Chemnitzer Straße 8 ǀ 14612 Falkensee ǀ www.HEITRONIC.de
Connection Lamp Protection type
1 W, 90 lm, 3000 K,
not replaceable
Protection
class
IP 20 III
2 / 4 01/24