Ransomes Jacobsen LKBB060 Betriebshandbuch Seite 14

6 ATTACHING THE UNIT
6.5 CONNECTING THE PTO
1. Connect the PTO to the Tractor and the Hyd
5/7 Mk4.(A). The PTO is fitted with an
overrun clutch that must be fitted at the
tractor end.
2. Secure the guards with PTO safety chains
(B). These should be attached to the Tractor
PTO guard and the Hydraulic 5/7 PTO guard.
6.6 CONNECT THE HYD 5/7 QUICK RELEASE
COUPLINGS.
1. Connect the Quick Release Couplings. (A)
Two Large Couplings (Cutting Circuit
Pressure/Return), Two Small Couplings
(Motor Drain/Unit 2/3 Lift). If the connectors
do not easily connect together there is
excess pressure in the circuit.
ENSURE UNITS 2/3 ARE LOCKED IN THE RAISED
POSITION OR FULLY LOWERED BEFORE
CONNECTING THE LIFT.
6.7 CONNECT THE HYD 5/7 TO TRACTOR
QUICK RELEASE COUPLINGS
1. Connect the Quick release couplings. (A)
The couplings need to be connected to the
Tractor Auxiliary Valves. The pressure port
on the Hyd 5/7 lift valve can be identified by a
(P) stamped into the Lift Valve Block.
DAMAGE COULD BE CAUSED BY CONNECTING
QUICK RELEASE COUPLINGS INCORRECTLY.
GB-12
RANSOMES HYDRAULIC 5/7 Mk IV Series: DM, CD, DL
SAFETY AND OPERATORS MANUAL