TCi IPC-ECO/ATX Handbuch Seite 17

3.5 Open the chassis
If you want to install new hardware, you must open the chassis. Please unscrew first on every
side the screws A. Before you can open the chassis, you have to push the top cover a little bit
to the backside.
3.6 Card installation and changing
Please attend of professional mounting Please attend of professional mounting Please attend of professional mounting Please attend of professional mounting
by authoris by authorise e e e d d d d personal. Furthermore
by authoris by authoris
the system must be separated the system must be separat the system must be separat the system must be separat
electricity supply and so that voltage electricity supply and so that voltage electricity supply and so that voltage electricity supply and so that voltage
free. free.
free. free.
By changing of cards or installation of new
cards please follow this points:
1. First open the screws (C) of the installed
card holders and take it out.
2. Dismantle now the slot at the new position
of the card. Now you can install the new
card. Screw now the screw (B) from the top
into the card holder. By using small cards
you have to use several stemp-parts (A1)
and the end part (A2)
3. Reintegrate the holder and fix the stemp
with screw (B). Attend to good position of
the end-part (A2), because the card must
installed into the indentation of the bottom.
Ludwig-Rinn-Str. 10-14
personal. Furthermore
personal. Furthermore personal. Furthermore
ed from the ed ed from the from the from the
D - 35452 Heuchelheim Phone: +49-(0)641-96284-0 Fax: +49-(0)641-96284-28 www.tci.de
Seite 17 von 24