Werbung
Transmitter Preparation
Power Switch
ON
OFF
Battery Level Indicator
Good Batteries
Low Batteries(Light Blinks)
Reverse Switch
反向开关
Servo Factory Settings
DIGITAL
PROPORTIONAL
RADIO CONTROL
SYSTEM
3ch Switch
4
This switch is used for optional parts.
Transmitter Battery Installation
Open battery cover at the bottom of transmitter.
Install batteries. Follow the direction of batteries
designated in the inside of battery box.
Antenna
Extend the antenna to the maximum
Length for best performance
Straight (neutral)
Left turn
DIGITAL
PROPORTIONAL
RADIO CONTROL
SYSTEM
4
Forward
To be used for throttle operation
Throttle Trigger
Battery Cover
27MHzTransmitter Crystal （TX）
Transmitter crystal(TX)
The crystal can be replaced to change frequencies.
Note : You must also change receiver crystals!
Do not use AM crystals
Right turn
1
3
2
Brake
Stop(Neutral)
8X
AA Alkaling Batteries
Receiver crystal(RX)
Steering Trim
1
To be used for trimming the steering
operation
Throttle Trim
2
To be used for trimming the throttle
operation
Steering Dual Rate
3
To be used to adjust steering servo throw
Werbung
