Installation
D Insert the handle bars (A) into the base bars (B)andsecurethem using one
bolt (C) and one cap nut (D).
D Attach the foot plates (F)to the base bars (as shown above).
D Securethem using 4 screws(E)for each plate.
Safety and Compliance
Readthe all instructions carefully.
D
This instruction manual contains important information for your safety as
D
well as operating and maintenance advice.
Observeall safety instructions to avoid damage through improper use.
D
Keepthis instruction manual for future use.Should this product be passed
D
on to a third party, the instruction manual must be included.
Forconsumer useonly.
D
Keeppackaging materials out of the reach of children.
D
Keepchildren and pets awayfrom the product.
D
Incorrect or excessivetraining may lead to injuries and/or serious health
D
consequences.
Always start with a gentle warm up (mild aerobic exerciseand/or
D
stretching).
Do not overexert yourself. In caseof chest pain or tightness, irregular
D
heartbeat, dizziness,nausea,or short breath, immediately stop exercising
and consult your physician.
D
Wear appropriate sport gear.
Perform a visual check of the product before each use. Do not usethe
D
product if it is damaged or defective. Defective components must be
replaced immediately. Failureto do so may impair the functioning and
safety of the unit.
Caution - Riskof Injury!
D
Sufficient spaceis required for safe training. Exercisewith enough safety
D
clearanceto other personsand objects to ensurethat no one is injured.
For household useonly.
D
This training equipment is in compliance with EN ISO20957-1 cl. 4.2 class
D
H (H = domestic).
Train on a flat, nonslip surface only.
D
Do not usethe product near stairs or landings.
D
Keepthe product indoors, away from moisture and dust.
D
Regularly checkthat all connections are tight.
D
The product is designedto support a maximum load of 661.39 lb (300 kg).
D
Freearea shall be not lessthan 23.6 inch (0.6 m) greater than the training
D
area.
Cleaning and Maintenance