SELF SLD75-24VFD-EU Bedienungsanleitung

Instruction for the use of
the LEDPOWER SUPPLY
Model:
SLD75-24VFD-EU,SLD100-24VFD-EU
SLD75-48VFD-EU,SLD100-48VFD-EU
Applications
This type of power supply is an exclusively designed
stabilized.
Power supply for LED lamp meets the requirements of
the RoHS Directive (2011/65 / EC), the Low Voltage
Directive (2014/35 / EU) and the EMC Directive
(2014/30 / EU).
With constant voltage (CV) technology, it is suitable for
constant voltage lamps(24V/48V) connected in series.It
also can be dimmable from 0.1%-100% through
DALI2.0.
The built-in protection circuit will shut down the power
supply incase of such faults as: short circuit, over load
or over temperature. The power supply will restart
automatically after fault correction.
Important information for the installation
·The unit uses dangerous mains voltage(220~240VAC),
it should only be installed by qualified electricians
according to European safety standards or relevant
nation regulations.
Failure to observe any of the installation instructions
may cause fire or other hazards.
·Dali interface is basically insulated from AC Input.
·Don't install a switch between output side and the lamp.
·The power supply is for LED lamps only. Pay attention
to the polarity of LED, wrong polarity may damage the
LED.
·The power supply is only for indoor use and
permissible operating temperature is -20 to +45℃.
·With terminal cover and cable clamp, the LED
power supply canbe independent installed.
· The indicated load should not be exceeded.
· The maximum length of the output cable to the
LED lamps should not exceed 2m in order to meet
the EMC standard.
· If the LED power supply is used for purposes other
than originally intended or it is connected
Incorrectly, the manufacturer is not responsible for
possible damages.
· Wasted PCB during transit, delivery, use and scrap
disposal can cause certain environment
damage.Please handle it according to "waste
electronic products disposal rules" locally.
Specifications
Input voltage:220~240VAC
Input frequency:50/60Hz
Input current: SLD75-24/48VFD-EU max.0.38A
SLD100-24/48VFD-EU max.0.50A
Input power factor:0.95
Standby power:
Constant output voltage: 24VDC/48VDC
Output current: SLD75-24VFD-EU 0-3.13A
SLD75-48VFD-EU 0-1.57A
SLD100-24VFD-EU 0-4.16A
SLD100-48VFD-EU 0-2.08A
Rated output power:
SLD75-24/48VFD-EUmax.75W
SLD100-24/48VFD-EUmax.100W
Ambient temperature:-20-+45℃
Case temperature:90℃
IP protection:IP20
Primary cable:0.75-1.5mm²
Secondary cable:
0.5W
0.75-1.5mm²