Royal Catering RCIC-5000T Bedienungsanleitung Seite 11

4. If the device is left without any operation for 4 hours while in use, it will
automatically shut off.
5. The surfaces of the appliance may become hot during operation.
6. The induction cooker is equipped with an overheating protection function. If
the temperature of the pot or plate becomes too high, the induction cooker
will automatically shut down, or the display light will flash. If this happens,
wait a few minutes for the cooker to cool down before restarting it. The
device will resume normal operation once it has cooled.
4. Usable and non-usable utensils
1. Usable Pans and Pots
Steel or cast iron; enamelled iron; stainless steel; flat-bottom pans/pots with diameter
from 16 to 30 cm.
2. Non-usable Pans and Pots
Heat-resistant glass; ceramic container; copper; aluminium pans/pots; rounded-
bottom pans/pots with bottom measuring less than 16cm.
5. Trouble shooting
Error Codes
Red LED flashes once
and switches off for 2
seconds
Red LED flashes twice
and switches off for 2
seconds
Red LED flashes three
times and switches off
for 2 seconds
Red LED flashes four
EN
Potential Reasons
No cooking utensil on the
stove or using an
inappropriate utensil
1. Device overheating
(e.g., covered ventilation
slots)
2. Parts are damaged
(e.g., transistor)
Stove-top overheating
Voltage
Solution
Place or replace a suitable pan with a
flat bottom
1. Clear the ventilation slots and let the
device cool off for a few minutes. Once
cooled, the device is ready for use.
2. If the error persists after cooling,
contact the supplier.
Ensure that there is water inside the
pan.
Verify that the voltage and frequency