Removing Sds-Plus Tool; Operation; Switching On/Off; Handle Attachment (Fig. 3) - Powerplus Powc1030 Bedienungsanleitung

7.2

Removing SDS-plus tool

Pull back fastening sleeve, hold and remove tool.
Accessories can be hot after use. Don't touch the tip of accessory by hand!
Please always use protective floves to remove accessory.

8 OPERATION

8.1

Switching ON/OFF

▪
Switching on:
▪
Switching off:
8.2

Handle attachment (Fig. 3)

For reasons of safety, only use the hammer drill with handle attachment.
You will be able to obtain a safe body position when working by rotating the handle attachment.
Loosen and turn the handle attachment in an ant-clockwise direction. Slip loop onto the neck
of the housing tool and position the handle, then tighten the handle attachment.
8.3

Hammer / drill switch

▪
The hammer/drill switch can switch the drill, hammer and hammer/ drill functions.
▪
To set the function, please use below compounding of front and rear hammer/drill switch.
Important! When hammer drilling you will require a low pressure. Too much
pressure will place unnecessary load on the motor. Check the drill bits
regularly. Re-sharpen or replace blunt drill bits.
Do not use the chuck with SDS connector in combination with the
hammer/hammer drill function!
Copyright © 2024 VARO NV
Press the operating switch (6).
Release the operating switch (6)
POWC1030
Hammer/ drill mode:
Drill in masonry, concrete and natural stone.
Don't use the hammer drill function for ceramic
tile or others material can not withstand impact
energy.
Hammer mode:
Drill in masonry, concrete and natural stone.
Drilling mode:
Drilling in wood, synthetic materials and metal.
P a g e | 6
WARNING! No function mode:
The motor turns without load,
the shaft will not turn. Do not
set the switch like this. It may
damage the motor greatly.
www.varo.com
EN