Antari HZ-100 Bedienungsanleitung Seite 4

♦
HC-1: 10 meter wired multi-function remote controller with ¼" stereo plug for ANTARI
Hazer models HZ-100 and HZ-400. Its two knobs allow the operator to program hazer
functions by adjusting haze emission duration and interval. Press the yellow TIMERS
button to activate the timer function. Adjust the interval between each haze emission
(within the range of 10 seconds to 5 minutes) by means of the INTERVAL control knob.
Adjust the duration of each haze emission (within the range of 1 to 10 seconds) by means
of the DURATION control knob. When pressed, the green MANUAL button activates the
hazer, overriding all other function controls. Press the red CONTINUOUS button for
continuous output.
♦
HCR-1: Wireless remote controller with ¼" stereo plug for ANTARI Hazer models HZ-100
and HZ-400. Attach the receiver's magnetic base to the hazer. Plug the receiver's cable
into the hazer's remote control input. Using the sending unit, your ANTARI Hazer can be
operated from a distance of up to 50 meters. Start haze emission by pressing the small
button on the sending unit. Stop haze emission by pressing the large button. Multiple
ANTARI Hazers may be controlled using only one sending unit.
DMX Operation (for HZ-400 only)
The HZ-400 has onboard DMX control. Currently, it uses 1 channel to control output
operation. The DMX channel is set on the back panel of the HZ-400 by setting the dip switches
to the desired channel. If Channel A has a value from 0 to 5, the unit is OFF. Between the
values 6 to 249 the HZ-400 produces haze.
Hazer Liquid
Do not allow the hazer liquid to become contaminated. Always replace the caps on the hazer
liquid container and the hazer's liquid tank immediately after filling.
ANTARI Hazer Liquid comes in two varieties:
♦
ANTARI HZL-1 is a high-performance low-residue oil-based hazer liquid that has been
designed specifically for HZ-100 and HZ-400.
♦
ANTARI HZL-1W is a non-residual water-based hazer liquid suitable for the HZ-100 and
HZ-400.
Important: Never mix oil-based and water-based hazer liquids. Before switching the kind of
hazer liquid in use, completely drain the hazer's tank to avoid mixing.
Save these instructions
4