Toro 108-8120 Montageanleitung

Traction Assist Handle Kit
Model No. 108–8120
Contents of the Kit
Description
Traction assist handle
Upper handle clamp
Lower handle clamp
Carriage bolts
Locknuts
Installing the Traction Assist
Handle
1. Stop the engine, and wait for all moving parts to stop,
and disconnect the wire from the spark plug.
2. Fasten the traction assist handle to the upper handle
clamp using 2 carriage bolts and locknuts (Fig. 1).
Ensure that the upper part of the traction assist handle
curves as illustrated in Figure 1.
1
2
Figure 1
1. Traction assist handle
2. Upper handle clamp
W 2005 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Quantity
1
1
1
4
4
3
m–8167
4
3. Carriage bolt (2)
4. Locknut (2)
Original Instructions (EN)
Installation Instructions
3. Center the rear edge of the upper handle clamp in the
groove in the lawn mower handle (Fig. 2).
5
4
3
6
Figure 2
1. Traction assist handle
2. Lawn mower handle
3. Upper handle clamp
(Rear edge installed in
the groove in the lawn
mower handle)
4. Place the lower handle clamp under the handle so that it
nests with the nuts on the upper handle clamp (Fig. 2).
5. Place 2 carriage bolts through both the upper and lower
handle clamps and secure the assembly using 2 locknuts
(Fig. 2).
6. Connect the wire to the spark plug.
1
Form No. 3353-472 Rev A
1
m–8168
2
4. Lower handle clamp
5. Carriage bolt (2)
6. Locknut (2)
Contact us at www.Toro.com
All Rights Reserved
Printed in the USA