Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.
Applications
The DC UPS is designed to provide emergency power backup to all kinds of DC-powered
equipment such as routers, modems, set-top box, VOIP phone systems, surveillance system,
alarm system, access control system and many critical telecom equipment.
5.
Important Safety Warning (SAVE THESE INSTRUCTIONS)
To safely operate this DC UPS, please read and follow all instructions carefully.
Read this manual thoroughly before attempting to unpack, install, or operate.
You may keep this quick guide for further reference.
CAUTION! Do NOT place this unit under the hot and humid environment.
CAUTION! Do NOT disassemble this product.
CAUTION! If the battery level is low, please recharge battery immediately.
CAUTION! When install or replace a new battery, be sure positive (+) and negative (-) are
correctly connected. Otherwise, DC UPS will be damaged.
5.
Trouble Shooting
Use the table below to solve minor problems.
Problem
Possible Cause
Red LED is on.
Overload or short circuit occurs
on UPS and UPS transfers to
fault mode.
Battery backup time is
Battery is far too low.
shorter than nominal
value.
No output and LED
Internal fault has occurred.
indicator is not on.
Solutions
Press button for more than 1 second
and release to restart unit.
Contact your dealer to replace the
special battery.
Contact your dealer.
6.
Specifications
AC INPUT
Voltage Range
Frequency
DC OUTPUT
Voltage
Max. Power
BATTERY
Type
Nominal Voltage
Capacity
Typical Charging time
PHYSICAL
Input Plug
Output cable
Dimension, D X W X H (mm)
Net Weight
7.
Approximate Back-up Time Table
Load
12V/1.0A Router
12V/1.5A Router
12V/2.0A Router
90 VAC ~ 264 VAC
50 or 60 Hz
12VDC ± 5%
25W (2.1A)
Lithium-ion Battery
3.7VDC
2600mAh
3 hours recover to 90% capacity
Type C (Schuko, French compatible)
1m Length (DC Male Jack, OD 5.5mm, ID 2.5mm)
68 x 42 x 74
200g
Backup Time @ 12Vdc (min)
150
120
90
Werbung
Inhaltsverzeichnis
