PowerWalker DC Bedienungsanleitung

PowerWalker DC SecureAdapter 12V
1.
Package Contents
You should have received the following items inside of package:
- DC UPS adapter unit
- Quick Guide
If anything is missing or damage in the package, please contact your dealer.
2.
Product Overview
A - Restart/Off Button
B - LED indicator
C - DC output connector
D - AC input
3.
Installation and Operation
NOTE: Before installation, please inspect the unit. Be sure that nothing inside the package is
damaged.
Connect to Utility and Charging
Plug in the AC input plug (D) to the wall outlet. The UPS will be
automatically turned on and green LED will light on. If battery is
not fully charged, the UPS will auto charge battery and green LED
will flash.
Connect the Loads
Plug in the loads to DC output connector (C) of the UPS. Then, connected device will be
protected by UPS unit.
LED Indication
This LED is two-color indicator: green or red color depending on operation status.
Status
Power on with battery fully charged.
Power on with charging battery.
UPS is on but power failure occurs. UPS will transfer to DC
mode and battery is discharging.
Any fault occurs on UPS.
Color On/Flash
Green On
Green Steady Flash
Green Quick Flash
Red On