Assembly Process - Yolco Rl90 Bedienungsanleitung

5. Directions for use cont.
• During installation, make sure there is sufficient space on the top (50mm), back (50mm) and sides of the unit (20mm). Ensure free airflow behind the
device. Ensure free airflow behind the device. The recess should have a ventilation opening with a minimum surface of 60cm2.
min
50
mm

Assembly process

1. Connect the power cord to the device.
2. Slide the device into the recess, making sure the power cord is not damaged.
First run
Carefully!
Wait about 6 hours before using the device for the first time.
1. Connect the device to a power source using the supplied cables.
2. Turn on the device and set the temperature to 4°C in the cooling compartment and -12°C in the frozen compartment. Wait an hour.
3. If the refrigerator is cooling, you can start using it.
Changing door opening direction.
To change the door opening direction:
1. Take all the products out of the appliance
2. Gently place the device in a horizontal position - with the door facing up
3. Unscrew the lower door hinge and the base on the opposite side. Then pull the appliance door downwards.
4. Unscrew the top door hinge and screw it in on the opposite side
of the appliance under the control panel strip.
5. Slide the door into the top hinge
6. Screw on the bottom door hinge and the base
7. Place the device in an upright position
8. Check that the appliance door closes smoothly.
If you encounter any resistance, check if the bottom
Hinge is not bent or over tightened.
min
60
cm²
min
50
mm
min
60
cm²
min
60
cm²
min
60
cm²
min
50
mm
min
60
cm²
min
60
cm²
min
50
mm
min
60
cm²
min
60
cm²