Environmental Protection - Ronix Rc-1012 Bedienungsanleitung

penetrating oils, etc., come in contact with plastic parts, Chemicals can
damage, weaken or destroy plastic which may result in serious personal
injury.
Electric tools used on fiberglass material, wallboard, speckling
compounds, or plaster are subject to accelerated wear and possible
premature failure because the fiberglass chips and grindings are highly
abrasive to bearings, brushes, commutators, etc. Consequently, we do
not recommend using this product for extended work on these types
of materials.
However, if you do work with any of these materials, it is extremely
important to clean the product using compressed air.
BEARING LUBRICATION
All of the bearings in this product are lubricated with a sufficient amount
of high grade lubricant for the life of the unit under normal operating
conditions. Therefore, no further lubrication is required.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing of as waste. The machine,
accessories and packaging should be sorted for environmental-friendly
recycling.
TROUBLESHOOTING
PROBLM
Loss of power or overheating
NO electrical power
Blown shop/house fuse
Shop/house breaker open
Compressor will
not run
Current limiting protector open
Pressure switch bad
Tank is full of air
30
Air Compressor 10 Liter
CAUSE
Check for proper use of extension cord
Check to be sure unit is plugged in
Check fuse/ breaker
Replace shop/house blow fuse
Reset shop/house breaker, determine
why problem happened
Motor will restart when cool
Compressor will tum on when tank
Pressure drops to cut- in pressure
POSSIBLE SOLUTION